Hand Held Piercing probe rtd
Piercing Probe RTD
Piercing probe temperature sensor is manufactured with heavy wall tubing to provide support for production line handling and a spring relief to prevent chafing of the Teflon insulated lead wires.
Piercing probe temperature sensor is manufactured with heavy wall tubing to provide support for production line handling and a spring relief to prevent chafing of the Teflon insulated lead wires.
The sensor can be configured to your dimensional requirements or it may be purchased off the shelf with a 0.188" O.D. stainless steel sheath, 4" in length, pointed tip and 10' of lead wire.
After following the schedule above, the lining is ready to accept molten metal. On the initial use, immerse the probe approximately 1/3 and hold for one minute. Continue immersing the probe until 2/3 covered and hold for one minute. Finally immerse the probe to the desired depth. This practice is only necessary on the initial use for sintering purposes.
Piercing Probe RTD Specifications
Platinum 100 Ohm, .00385 Alpha
4 wire configuration
Temperature Range - 50oC to 150oC
DIN Class B, ? 0.12% ohms at 0 oC
Celsius = 0.3 ohms + (.005 ohms x (temperature) )
Sheath is polished for 3A Sanitary service.
Minimum wall thickness of sheath = .028".
sales@thermometricscorp.com